Bent Panel Repair

Garage doors have a particular complication that makes them susceptible to wear and technical faults that might be difficult to see. Occasionally, accidents occur, and garage doors are damaged as a result of collision or weather. The garage door may still work correctly in some situations, but there are visual and aesthetic concerns. In other cases, the damage to the Garage Door Panels may be severe enough to prevent the garage door from moving.

Paragon Garage Doors in Washington offers complete bent garage door and bent garage door panel repair in either case. We understand the irritation and difficulty of a garage door that isn’t working correctly due to bent panels, as well as the unsightly appearance of a bent garage door. However, bent and broken garage door panels should be fixed or replaced promptly to prevent further damage to your garage door or the door opening system.
We can check and repair your broken garage door or bent panels quickly, safely, and inexpensively with our emergency service.

A bent or buckling top panel is one of the most typical service requests we receive. Almost always, there are two causes for this issue: the opener is hanging too high, and the door lacks a strut. Therefore, supporting the top portion of your garage door is critical in avoiding a potentially costly service visit.
If the top portion isn’t properly supported, it can flex until it splits in half. If this occurs, the bent part of the garage door, or perhaps the entire garage door, will need to be replaced.

Some of you may have already decided to replace the top portion. However, the Parts of the garage doors are not all the same. Patterns and colors change slightly depending on the manufacturer and model. Therefore, it’s critical to identify the manufacturer and model number, which may generally be found on a sticker on the section’s side.

Some garage doors are composed of metal, while others are built of a combination of metal and wood, such as an internal metal garage door with beautiful wood on the exterior. A car hitting the garage door can bend the panels, or a fault might cause them to bend.

Based on the state of the panels, garage door bent panels repair and replacement services like ours will provide you with two alternatives. First, the panels can be fixed onsite if they are slightly bent. Second, repairing the panels is less expensive than replacing them entirely.

If we notice that the panels are beyond repair, we must replace them. We have skilled garage door panel installers that will locate and install the appropriate panels for your door. Not only that, but we’ll make sure the panels are aesthetically pleasing as well.